Skip to main content
After completing this workflow, you can save a Panel’s Channel selection and chart settings once as a Panel Configuration and apply them to any Run, swapping only the data source instead of rebuilding the layout each time.

​
Before you begin

  • You have a Run with ingested telemetry data open in Explore.

​
How Panel Configurations work

A Panel Configuration saves a Panel’s visualization setup, including Channel selection and chart settings, so it can be applied to any Panel in any future session. When you open Explore for a new Run, you apply the configuration and only swap the data source. Your Channels, layout, and settings are already in place.

​
Example

For example, a team reviewing battery health after every engine test can save their standard voltage, current, and temperature Channels once and open the same layout for every new Run, without rebuilding it each time.

​
Save a Panel Configuration

  1. In Explore, plot the Channels you want to reuse in a Panel.
  2. In the Panel, click to open the Panel settings and configure them as needed.
  3. Click Save configuration as….
  4. In the Panel Configuration Name box, enter a name for the Panel Configuration.
  5. Optional: Clear Channel List & Settings to exclude Channel selections from the configuration.
  6. Optional: Clear Timeseries Panel Settings to exclude chart settings from the configuration.
  7. Click Save.

​
Apply a Panel Configuration to a new Run

  1. Select Runs in the navigation, then search for the Run you want to analyze with a Panel Configuration.
  2. In the Runs table, click the Run.
  3. Click Explore.
  4. Click the Panel Configurations tab.
  5. Select the Panel Configuration you want to apply.
    • Only Panel Configurations that have at least one Channel name matching the selected data source are shown.
  6. Select how you want to apply the configuration and click Apply.
  7. Optional: To swap the data source without rebuilding the layout, right-click a data source in the Channels tab, select Replace data source, choose a replacement Run or Asset, click Preview changes, review any warnings, and click Confirm replacement.

​
Overwrite a Panel Configuration

When your standard Channel set or settings change, overwrite the existing configuration to keep it up to date.
  1. Apply a Panel Configuration to a Panel.
  2. Update the Channels or settings in the Panel as needed.
  3. In the Panel, click to open the Panel settings.
  4. Click Save configuration as….
    • The Overwrite Existing tab is selected by default with the last applied configuration pre-selected.
  5. Optional: Select a different Panel Configuration to overwrite from the Existing Configuration to Overwrite list.
  6. Click Save.

​
Reference